How to Send Jobs to the Clock

If you want to program your clock to display your jobs, you will need to send the jobs to the clock.

Jeffrey Mo avatar
Written by Jeffrey Mo
Updated over a week ago

You can program your clock to display jobs that employees can select when punching in.

To tie a specific job to a specific clock, see How to Map a Clock to a Job.

Note: Only jobs with numerical values for codes are sent to clocks.

How to send a job to a clock

  1. Log in to Fingercheck as an Administrator.

  2. Make sure you have jobs already built.

  3. Go to the SETUP tab > Clock Management (under the Company heading).

  4. Select the clock terminal you want to send jobs to.

    The Terminal Information section appears.

  5. From the Workcode Option drop-down list, select JobCode.

  6. From the hamburger icon in the top right, select Sync WorkCodes.

  7. Click Go.

    A message will pop up informing you that only work codes with a numeric value will be sent.

  8. Click OK to continue.

  9. Click Save.

Thank you for using Fingercheck. If you have any questions on this article's topic, you can reach out to our team at 1-800-610-9501, or use the chat option below.

Did this answer your question?